Hbx1605 200mm / 7.87" linear motion guide actuator double linear rail slide 1605 ballscrew motorized xy xyz linear stage table nema23 stepper motor for diy cnc router engraver machine built for smooth motion, steady alignment, and clean installs

Hbx1605 200Mm Linear Motion made for smooth installs and clean fit
✔️ Hbx1605 200mm / 7.87" linear motion guide actuator double linear rail slide 1605 ballscrew motorized xy xyz

This 1 pack is meant for clean replacement or upgrade work where fit and smooth operation matter.

✅ Product structure analysis - nema23 stepper motor + motor flange plate + coupling + bearing support seat + double line rail slide table + 1605 ball screw + slide table + bearing seat + base. horizontal load: 60kg/132.28 ib
✅ Vertical load: 30kg/66.14 ib.
✅ Nema23 stepper motor - motor length: 56mm. motor flange size: 57mm. holding torque: 1.2n.m. phase: 2. current: 3a. resistance: 0.8 ω. inductance: 2.4mh. rotor inertia: 440g.cm. wiring: red(a+), green(a-), yellow(b+), blue(b-).
✅ 1605 ball screw - drive type:1605 ball screw. effective travel length: 200mm/7.87inch. screw precision grade: c7. screw pitch: 5mm. flange nut screw rod with precision up to 0.003mm. high efficiency and low noise.
✅ Features - double line rail sliding table design, high precision, more stable operation. adding bearing support seat, high concentricity. sliding nut design on the side, limit switch can be installed at any position. the slider is made of 6030 aluminum and are oxidized, which is beautiful and generous.

💡 What lubrication setup helps a ballscrew run smoother at higher speeds?
Quick answer: match pitch, travel length, and support style to your axis load and speed.
* Pitch controls feed rate and torque demand
* Proper end supports keep alignment tight under load
* Good lubrication cuts heat and wear over time

Built to keep motion smooth and accuracy steady during long production runs.